ECQE4103JF3

ECQE4103JFW

ECQE4103KFA

Vendor:ＰＡＮＡＳＯＮＩＣ

ECQE4103KFW

ECQE4104JF3

ECQE4104JFW

ECQE4104KF

Vendor:PANASONICD/C:07/08+

VOUT Temperature Coefficient DC Crosstalk2 REFERENCE INPUTS2 VREF(+) DC Input Impedance VREF(−) DC Input Impedance VREF(+) Input Current VREF(+) Range VREF(−) Range REFGND INPUTS2 DC Input Impedance Input Range OUTPUT CHARACTERISTICS2 Output Voltage Range

ECQE4104KFB

ECQE4104RJF

ECQE4105KFB

ECQE4123JF9

ECQE4123KF

ECQE4123KFB

ECQE4123KFW

ECQE4123RJF

ECQE4124JFB

ECQE4124KF3

ECQE4124KFB

ECQE4124RJF

ECQE4125KFB

ECQE4125KZ

ECQE4153KF

ECQE4153KZ

ECQE4153RJF

ECQE4154JF

ECQE4154JF3

ECQE4154JFB

ECQE4154KF

Vendor:ＰＡＮＡＳＯＮＩＣ

ECQE4154KFB

ECQE4155JFW

ECQE4155KF

ECQE4155KFB

ECQE4183JF3

ECQE4183JF9

ECQE4183JFW

ECQE4183KF

ECQE4183KFB

ECQE4183KZ

ECQE4183RJF

ECQE4184JFB

ECQE4184JFW

ECQE4184KFW

ECQE4184RKF

ECQE4223JF

ECQE4223KF

ECQE4223KF3

ECQE4223KF9

ECQE4223KZ

ECQE4223RKF

ECQE4224KF

Vendor:ＰＡＮＡＳＯＮＩＣ

ECQE4224KFB

ECQE4224KZ

ECQE4225JFB

ECQE4225KF

Vendor:ＰＡＮＡＳＯＮＩＣ

Hybrid high dynamic range optical receiver module in a SOT115R package operating at a voltage supply of 24 V (DC). The module contains a monomode optical input suitable for wavelengths from 1290 to 1600 nm, a terminal to monitor the pin diode current and an electrical output with an impedance of 75 Ω. The optical fibre is terminated by an FC/APC connector (JDS version) and partly reinforced by ...

ECQE4225KFB

ECQE4273JFW

ECQE4273KFW

ECQE4273RJF

ECQE4273RKF

Falling or rising edge as determined by the control bits of serial word. Strong or weak SDO driver selected via the control register. Daisy-chain and readback modes cannot operate at maximum clock frequency. SDO timing specifications measured with a load circuit, as shown in Figure 4.

ECQE4274JFB

ECQE4274JFW

ECQE4274KF

- Updated info for SMRAM3P5K2E in device memory map - Updated EXTAL and XTAL supply rail information. - Relocate SCI module base address from $70 to $C8 - Relocate ATA5HC module base address from $240 to $1C0 - Relocate PIM module base address from $80 to $240 - Relocate Interrupt Vectors - Updated Phy evaluation pinout. - Updated CFA00, CFA01 and CFA02 pin name to CFA0, CFA1 and CFA2 respectively. ...

ECQE4274KZ

ECQE4333KF

Vendor:Panasonic

The LT®4256-3 is a high voltage Hot Swap controller that allows a board to be safely inserted and removed from a live backplane. An internal driver controls the high side N-channel MOSFET gate for supply voltages ranging from 10.8V to 80V. The part features an open-circuit detect (OPEN) output that indicates abnormally low load current conditions.

ECQE4333KF9

ECQE4333KZ

ECQE4334KF

Vendor:ＰＡＮＡＳＯＮＩＣ

The EWEN/EWDS instruction will enable or disable the programming capabilities. At both the power on and power off state the device automatically entered the dis- able mode. Before a WRITE, ERASE, WRAL or ERAL in- struction is given, the programming enable instruction EWEN must be issued, otherwise the ERASE/WRITE in- struction is invalid. After the EWEN instruction is issued, the programming enable condition...

ECQE4334KF

Vendor:ＰＡＮＡＳＯＮＩＣ

The EWEN/EWDS instruction will enable or disable the programming capabilities. At both the power on and power off state the device automatically entered the dis- able mode. Before a WRITE, ERASE, WRAL or ERAL in- struction is given, the programming enable instruction EWEN must be issued, otherwise the ERASE/WRITE in- struction is invalid. After the EWEN instruction is issued, the programming enable condition...

ECQ-E4334KF

ECQE4334KFW

ECQE4334RJF

ECQE4334RKF

ECQE4393JF9

ECQE4393JFW

ECQE4393KFB

ECQE4394JFB

ECQE4394KF3

ECQE4394KFB

ECQE4394KFW

ECQE4394KZ

ECQE4473JFW

ECQE4473KF

The device will respond with a 64-bit ATR code, including historical bytes to indicate the mem- ory density within the CryptoMemory family. Once the asynchronous mode has been selected, it is not possible to switch to the synchronous mode without powering off the device.

ECQE4473KF

The device will respond with a 64-bit ATR code, including historical bytes to indicate the mem- ory density within the CryptoMemory family. Once the asynchronous mode has been selected, it is not possible to switch to the synchronous mode without powering off the device.

ECQE4474B312

Vendor:ＰＡＮＡＳＯＮＩＣ

ECQE4474JF

ECQE4474JFW

ECQE4563JF

ECQE4563JF3

ECQE4563JFW

ECQE4563KF

Features • 0.2% Initial Tolerance Max. • Guaranteed Temperature Stability • Maximum 0.6 Ω Dynamic Impedance • Wide Operating Current Range • Directly Interchangeable with LT1009 and LM136 for Improved Performance • No Adjustments Needed for Minimum Temperature Coefficient • Meets Mil Std 883C ESD Requirements • Extended Operating Temperature Range for Use i...

ECQE4563KFW

ECQE4563RJF

ECQE4564KZ

ECQE4683KF3

ECQE4683KFB

ECQE4683KZ

ECQE4684KFB

ECQE4684KZ

ECQE4823JFW

ECQE4824JFB