Index "R"Vendor:YAGEOD/C:2009+
Vendor:YAGEOPackage Cooled:SMDD/C:2009+
Vendor:YAGEOD/C:0612
Vo1/Vo2 Loading The output voltages from the RC1206FR-075K6 series regulators are independently regulated. The voltage at Vo1 is produced by a highly efficient switching regulator. The lower output voltage, Vo2, is derived from Vo1. The regulation method used for Vo 2 also provides control of this output voltage during power-down. Vo2 will sink current if the voltage at Vo1 attempts to fall below it.
Vendor:YAGEOPackage Cooled:SMDD/C:2009+
Die nachfolgend angefhrten R/T-Kennlinien sind auf den Widerstandswert 25 C normiert. Die tatsächlichen Widerstandswerte der betreffenden Heißleiter erhält man durch Multiplikation der Verhältniszahlen RT/R25 (Tabellenwert) mit dem Widerstandswert bei 25 C (in den Datenblättern angegeben).
Vendor:YAGEOD/C:2009+
Die nachfolgend angefhrten R/T-Kennlinien sind auf den Widerstandswert 25 C normiert. Die tatsächlichen Widerstandswerte der betreffenden Heißleiter erhält man durch Multiplikation der Verhältniszahlen RT/R25 (Tabellenwert) mit dem Widerstandswert bei 25 C (in den Datenblättern angegeben).
Vendor:YAGEOPackage Cooled:SMDD/C:2009+
Package Cooled:yageo
3-wire FSK Interface Data (CMOS Output). Mark frequency corresponds to logical 1. Space frequency corresponds to logical 0. In mode 0 (when the CB0 pin is logic low) the FSK serial bit stream is output to the DATA pin directly. In mode 1 (when the CB0 pin is logic high) the start bit is stripped off, the data byte and the trailing stop bit are stored in a 9 bit buffer. At the end of each word signalled by ...
Package Cooled:yageo
3-wire FSK Interface Data (CMOS Output). Mark frequency corresponds to logical 1. Space frequency corresponds to logical 0. In mode 0 (when the CB0 pin is logic low) the FSK serial bit stream is output to the DATA pin directly. In mode 1 (when the CB0 pin is logic high) the start bit is stripped off, the data byte and the trailing stop bit are stored in a 9 bit buffer. At the end of each word signalled by ...
Vendor:YAGEOPackage Cooled:SMDD/C:2009+
Vendor:YAGEOPackage Cooled:722
Vendor:YAGEOD/C:08+
Vendor:YAGEOD/C:2009+
Vendor:YAGEOD/C:2009+
Vendor:YAGEOPackage Cooled:SMDD/C:2009+
Vendor:YAGEOD/C:08+
• Hot-swapping and hot-docking (low resistance for PCI and Compact PCI applications) • Bus switching and isolation • Voltage translation (5V to 3.3V) • Capacitance reduction and isolation • Power conservation • Logic replacement (data processing) • Clock gating
Vendor:YAGEOPackage Cooled:SMDD/C:2009+
Vendor:KOA
Vendor:YAGEOD/C:2009+
Vendor:YAGEOPackage Cooled:SMDD/C:2009+
Vendor:YAGEO CORP
Vendor:YAGEOPackage Cooled:SMDD/C:2009+
Vendor:YAGEOPackage Cooled:SMDD/C:2009+
Vendor:YAGEOPackage Cooled:SMDD/C:2009+
Vendor:YAGEOPackage Cooled:SMDD/C:2009+
Vendor:YAGEOPackage Cooled:SMDD/C:2009+
Vendor:YAGEOD/C:08+
Vendor:YAGEOPackage Cooled:SMDD/C:2009+
Vendor:YAGEOPackage Cooled:SMDD/C:2009+
Vendor:YAGEOPackage Cooled:SMDD/C:2009+
Vendor:YAGEOD/C:08+
Minimum Breakdown Voltage: The minimum voltage the device will exhibit at a specified current. Working Peak Reverse Voltage: The maximum peak voltage that can be applied over the operating temperature range. Maximum Forward Voltage: The maximum forward voltage the device will exhibit at a specified current. Maximum Leakage Current: The maximum leakage current that will flow at the specified voltage and tem...
Vendor:YAGEOD/C:2009+
Vendor:YAGEO CORP
Vendor:YAGEO CORP
Vendor:YAGEO CORP
Vendor:YAGEO CORP
Vendor:YAGEO CORP
Vendor:YAGEO CORP
Vendor:YAGEO CORP
Vendor:YAGEO CORP
Vendor:YAGEO CORP
Vendor:YAGEO CORP
Vendor:YAGEO CORP
Vendor:YAGEO CORP
Vendor:YAGEO CORP
Vendor:YAGEO CORP
Vendor:YAGEO CORP
Vendor:YAGEO CORP
Vendor:YAGEO CORP
Vendor:YAGEO CORP
Vendor:YAGEO CORP
The device is entirely command set compatible with the JEDEC single-power-supply Flash standard. Commands are written to the command register using standard microprocessor write timing. Register con- tents serve as inputs to an internal state-machine that controls the erase and programming circuitry. Write cycles also internally latch addresses and data needed for the programming and erase operations. Read...
The RBM Micro Size DC/DC-Converter comple- ments Recoms industrial range of converters. This range is widely used for pcb distributed power systems and combines small package size, high efficiency, 3kVDC isolation and low out- put ripple. The extended operating temperature range covering C40C to +85C is a standard feature. The full rated power can be taken from a single pin of this dual output converter, p...
Vendor:YAGEO CORP
Vendor:YAGEO CORP
Vendor:YAGEO CORP
Vendor:OKIPackage Cooled:SMDD/C:07+
Package Cooled:08+D/C:07+
Inputs Are TTL-Voltage Compatible Internal Look-Ahead for Fast Counting Carry Output for n-Bit Cascading Synchronous Counting Synchronously Programmable Package Options Include Plastic Small-Outline (M), Standard Plastic (E) and Ceramic (F) DIPs
Vendor:YAGEOPackage Cooled:SMDD/C:07+
1) CPD is defined as the value of the ICs internal equivalent capacitance which is calculated from the operating current consumption without load. (Refer to Test Circuit). Average operating current can be obtained by the following equation. ICC(opr) = CPD x VCC x fIN + ICC/2(per circuit)
Vendor:YAGEOD/C:07+
1) CPD is defined as the value of the ICs internal equivalent capacitance which is calculated from the operating current consumption without load. (Refer to Test Circuit). Average operating current can be obtained by the following equation. ICC(opr) = CPD x VCC x fIN + ICC/2(per circuit)
Vendor:YAGEO CORP
The Acknowledge (ACK) Bit shown in Figure 2 is provided by the Configurator receiving the byte. The receiving Configurator can accept the byte by asserting a Low value on the cSDA line, or it can refuse the byte by asserting (allowing the signal to be externally pulled up to) a High value on the cSDA line. All bytes from accepted messages must be terminated by either an Acknowledge Bit or a Stop Condition....
Vendor:YAGEOPackage Cooled:SMDD/C:2009+
Vendor:YAGEOPackage Cooled:SMDD/C:2009+
Vendor:YAGEO CORP
CAUTION: Stresses above those listed in Absolute Maximum Ratings may cause permanent damage to the device. This is a stress only rating and operation of the device at these or any other conditions above those indicated in the operational sections of this specification is not implied.
Vendor:YAGEOPackage Cooled:SMDD/C:2009+
Vendor:YAGEOPackage Cooled:SMDD/C:2009+
Vendor:YAGEO CORP
The Infineon single mode ATM transceiver complies with the ATM Forums Network Compatible ATM for Local Network Applications document and ANSIs Broadband ISDNCus- tomer Installation Interfaces, Physical Media Dependent Speci- fication, T1.646-1995, Bellcore - SONET OC-3 / IR-1 and ITU-T G. 957 STM-1 / S.1.1.
Vendor:YAGEOPackage Cooled:SMDD/C:2009+
Vendor:YAGEOPackage Cooled:SMDD/C:2009+
Vendor:YAGEOPackage Cooled:SMDD/C:08+
The maximum output is set to VMAX, the minimum output to VMIN and the average output to VAVE. 6) Integration time is 10ms. 7) VOUT = 500mV 8) DR = VSAT/VDRK When optical accumulated time is shorter, the dynamic range gets wider because dark voltage is in propagation to optical accumulated time. 9) SE = VSAT/R1 10) VOS is defined as indicated below.
Vendor:YAGEOPackage Cooled:SMDD/C:2009+
Vendor:YAGEOPackage Cooled:SMDD/C:2009+
Vendor:YAGEOPackage Cooled:SMDD/C:08+
CNC7S101 is an AC input compatible optoisolator in which two GaAs high output infrared light emitting diode chips are connected in reverse parallel as light emitting elements, and opitically are connected to a high sensitivity Si phototransistor chip as a light detecting element in a small DIL 4-pin package.
Vendor:YAGEOPackage Cooled:SMDD/C:2009+
Code protection is constantly evolving. We at Microchip are committed to continuously improving the code protection features of our products. Attempts to break microchips code protection feature may be a violation of the Digital Millennium Copyright Act. If such acts allow unauthorized access to your software or other copyrighted work, you may have a right to sue for relief under that Act.
The receiver offers an exceptionally high level of integration and performance to meet the local oscillator radiation requirements of regulatory authorities world wide. Functionally the device works in the same way as the KESRX01 with the added features of low supply voltage, in-band interference rejection (anti-jamming detector), a 2-stage power down to enable receiver systems to be implemented with...
Vendor:YAGEOPackage Cooled:SMDD/C:2009+
The CP3SP33 connectivity processor is an advanced mi- crocomputer with system timing, interrupt logic, instruction cache, data memory, and I/O ports included on-chip, mak- ing it well-suited to a wide range of embedded applications. The block diagram on page 1 shows the major on-chip com- ponents of the CP3SP33.
Vendor:YAGEOPackage Cooled:SMDD/C:08+
The MAX4599 successfully meets the quality and reliability standards required of all Maxim products. In addition, Maxims continuous reliability monitoring program ensures that all outgoing product will continue to meet Maxims quality and reliability standards.
Vendor:yageoPackage Cooled:yageoD/C:dc05
Note 1: Absolute Maximum Ratings are those values beyond which the life of a device may be impaired. Note 2: TJ is calculated from the ambient temperature TA and power dissipation PD according to the following formula: RC1206JR0718KCG: TJ = TA + (PD 95C/W) RC1206JR0718KCUHF-1: TJ = TA + (PD 34C/W) Note 3: The IC is tested in a feedback loop that includes the differential amplifier in a unity-gain conf...
Vendor:YAGEOPackage Cooled:SMDD/C:08+
The Am186ED/EDLV microcontrollers have been designed to meet the most common requirements of embedded products developed for the communications, office automation, mass stor age, and general embedded markets. Specific applications include PBXs, multiplexers, modems, disk drives, hand-held and desktop terminals, fax machines, printers, photocopiers, and industrial controls.
Vendor:YAGEO CORP
1. VIH (max) = 3.0V AC.The overshoot voltage duration is 3ns. 2. VIL (min) = -2.0V AC. The undershoot voltage duration is 3ns. 3. Any input 0V VIN VDDQ. Input leakage currents include Hi-Z output leakage for all bi-directional buffers with tri-state outputs. 4. Dout is disabled, 0V VOUT VDDQ.
Vendor:YAGEOPackage Cooled:SMDD/C:08+
Vendor:YAGEOPackage Cooled:SMDD/C:2009+
Vendor:YAGEOD/C:2009+
Vendor:YAGEO CORP
Vendor:NXP
Vendor:YAGEOPackage Cooled:SMDD/C:2009+
Vendor:YAGEOPackage Cooled:SMDD/C:2009+
Vendor:YAGEOD/C:2009+
Vendor:YAGEOPackage Cooled:SMDD/C:2009+
Vendor:YAGEOPackage Cooled:SMDD/C:2009+
Vendor:YAGEO CORP
Vendor:NXP
OPA682UThe OPA682U uses internal resistors to set the gain at +1, +2, or C1. Pin 8 disables the output when low. Table VIII shows different ways to set up pin 8s voltage using R8, R9 and C7. Use Table III for the other components, except for the changes shown in Table IX.
Vendor:YAGEOPackage Cooled:SMDD/C:2009+
Vendor:YAGEO CORP
Note: 1. All input pulses are supplied by a generator having the following characteristics: tr or tf 1ns, Pulse Repetition Rate (PRR) = 50 Mpps, Pulse width = 10 0.2ns. CL includes instrumentation and fixture capacitance within 0.06m of the D.U.T. The measurement of VOC(PP) is made on test equipment with a C3dB bandwidth of at least 300MHz.